2p Operation


2p Field Sensor

All measurements shown in inches

Ambient Illumination Sensor (AIS), data cable, Ethernet cable

As a general rule, connect the AIS to the 2p sensors before startup, and do not disconnect until after shutdown. The white connector on the data cable plugs into the field sensor, and the black connector plugs into the AIS. The system will boot up as soon as power is connected to the field sensor; use the button on the AIS only when shutting the system down. The AIS lights indicate system status.

All measurements shown in inches

The sensor will store approximately 3.5 hours of data before the AIS LED begins to blink red. After 4 hours, the 64 GB memory card will reach full capacity, and the AIS LED will show solid red. Save the data and clear the memory card regularly.

results matching ""

    No results matching ""